 |
  |
|
|
|
The
stock bolts from you r decklid stands will only work for the
mounting of the standoffs to the decklid stands. You will need to
purchase some additional bolts. I got these at home depot for $1.00.
You need these in order to have adjustment on your standoffs The
standoff The bolt
to the left is the stock one, the middle one is 6mm-10x16mm, and the
one on the right is 6mm-10x20 Stock
setup on the decklid This is
the only place where you will use your stock bolts This is
the only place where you will use your stock bolts Using
the stock bolts on the rear mounting points of the standoffs here
will not give you any adjustment and they do not fully screw in Using
the stock bolts on the rear mounting points of the standoffs here
will not give you any adjustment and they do not fully screw in Standoff
in place 6mm-10x16mm
bolts used here,I recommend using washers in hindsight The
6mm-10x20 mm bolts are used here so you have adjustment Job done
|
|
|